| Connected
to the compressor, allows to replace brakes (and hydraulic clutches) fluid, carrying
out perfect air bleeding in a few seconds.
It is directly connected to the brake calipers vent valves with no need of removing the brake pipes of the bike.
All-purpose, extremely rapid and
clean.
Weight
Kg 0.64
Delivery in 5-15 days from your order.
| DIRECTIONS FOR USE
Rear brake system (hydraulic clutch)
1 - Connect the depressor to the compressor
and to the vent valve of the brake caliper or of the clutch.
2 - Open the
small bike reservoir where the fluid is contained.
3 - Operate the depressor
and at the same time open the vent valve, till all the system fluid is out (taking
about 30 seconds).
4 - Put clean fluid into the fluid reservoir and start
the depressor again until the fluid will start to go out from the vent (also taking
30 seconds)
5 - You can now close the vent valve and disconnect the depressor.
6 - Close the fluid reservoir on the bike and the job is finished.
Front brake
system
Same as above.
In case you have two calipers and the vent on the
master cylinder, operations 1-2-3 and then 4-5 will be made on the second caliper
too and on the master cylinder vent, if any. | | |
#653908
|
