|
||||||||||||||||||||||||||||
|
| Accumate battery (batteries) charger (chargers) for motorbikes (made by TecMate - Belgium) |
||||
|
||||
Optimate 4 battery charger The micro-processor controlled OptiMate 4 can save neglected batteries. The OptiMate 4 is even more effective, with a new dual-stage recovery + turbo recovery action. For modestly neglected deep-discharged batteries the recovery mode engages automatically, while the turbo recovery mode engages for more severely neglected batteries. The automatic multi-stage programme engages as soon as the OptiMate is connected to a 12 V battery retaining at least 2 V. The OptiMate's high voltage desulphation mode cannot engage unless the battery is first disconnected from the vehicle's electrical system. However, even if the battery is not disconnected, the OptiMate 4 cannot damage sensitive vehicle electronics as the higher voltage mode can only engage if minimal or zero current is flowing into the battery. |
|
|||
| Accumate battery charger Accumate charges at 1.2 A constant current (with maximum efficacy and minimum time) until the voltage rises to 14.3 V, just before gassing. Then it maintains this voltage till the battery current comes to 200 mA. Voltage is then limited to 13.6 V for battery maintenance. During this condition, the current arriving to the battery is continuously monitored and, if it exceeds 200 mA, the charging programme will be restarted. The yellow and green LEDs show the battery charging conditions. It is absolutely safe, also for unskilled users. It is electronically protected against short circuits and reversals of polarity. No sparks, even in case of short circuit. Supplied with waterproof connecting cable to the battery for fast connection of AccuMate battery charger. You just have to connect the two red / black clips to your car / bike battery directly, and leave them always connected. Then, fix the other end of the cable in a place easy to reach. You can this way connect the Accumate battery charger at any time, easily and rapidly, with no need to disconnect anything from your car / bike. Fuse-holder with 10 A fuse is also supplied within. AccuMate battery charger is ideal for quick recharging batteries of racing motorbikes, scooters and cars. |
|
|||
AccuMate Compact battery charger The plug pins can be rotated 90° in relation to the body of the charger to allow it to be plugged into sockets even where there is some obstruction close by. Furthermore, each charger comes with a selection of plastic plug props that can be plugged into (and protrude from) holes in the lower edge of the charger housing so as to relieve the stress on the socket due to the weight and rotational leverage of the charger. Charging circuit will engage and attempt to recharge any 12 V lead-acid battery retaining at least 2 V at the moment of connection; i.e. even a very flat battery. 3 m long output cable, plus 2 detachable and replaceable connection sets, the one with metal eyelets for permanent fixing to the battery posts and easy and quick connection / disconnection to batteries on the vehicle, the other with battery clips for charging and maintenance of batteries removed from the vehicle. Full electronic protections against user error such as output short-circuit & wrong battery connections. Spark generation is suppressed even in short-circuit. |
|
|||
TestMate Mini Tester A simple, easy to use portable battery and charging system tester for any vehicle (or outdoor power equipment) with a 12 V starter battery. No disassembly or tools required. Just connect the TestMate Mini to the battery terminals and turn the ignition key or push the starter button to crank the engine. Battery strength and charging system operation can be checked in seconds without even getting your hands dirty! The TestMate Mini is more than just a voltmeter. It’s a super fast recorder of instant volt drop during ‘engine’ cranking – the best indication of a starter battery’s ability to deliver power when the engine needs it most. Once the engine runs it checks if the charging system voltage is correctly set for the battery, and whether it is able to bring the battery back to full charge. This unique, pocket-sized on vehicle battery and charging system tester: For any vehicle with 12 V battery system, any battery size and any charging system. 18 LEDs precisely indicate full cranking and charging range from 7 V to 15 V. Light and water-resistant it's ideal for outside testing or carrying around in your toolbox. The rear panel can be demounted to fit temporary and permanent fixing mounts. Cable straps and velcro strips are included with each TestMate Mini. Connects directly to OptiMate and AccuMate fixed battery leads. |
|
|||
| | ||||||||||||||||||||||
|
Connector for standard cigar
socket Weight Kg 0.06
Delivery in 5-15 days from your order. |
![]() #450132 |
Optional battery connecting
cable (waterproof) Weight Kg 0.05
Delivery in 5-15 days from your order. |
#450137 | |||||||||||||||||||
Battery connecting cable (no waterproof) Weight Kg 0.04
Delivery in 5-15 days from your order. |
![]() #450133 |
DIN connecting cable (water-proof) Weight Kg 0.01
Delivery in 5-15 days from your order. |
![]() #450134 |
|||||||||||||||||||
Couple of battery clamps Weight Kg 0.06
Delivery in 1-5 days from your order. |
#450138 |
Connector for navigator (waterproof) Weight Kg -
Delivery in 5-15 days from your order. |
![]() #450197 |
|||||||||||||||||||
|
|
|||||||||||||||||
|
|||||||||||||||||